Welcome to Installation

cancel
Showing results for 
Search instead for 
Did you mean: 
Need help?

HB between Explora 1 & 2

SOLVED
1 REPLY 1
Red Carpet

Re: HB between Explora 1 & 2

Explora 1 and Explora 2A both have RF IN and RF OUT ports.

If the two decoders are in the same room next to each other, all that is required is an HB cable between the two and no diplexer.

If the two decoders are in a different room then the options would be to extend the HB cable to the other room or run HB via the LNB cables and the switch.

 

THEN a diplexer is required behind the Explora 1, to inject/receive the HB signal on the LNB cable. The Explora 2A will be able to receive/send HB via the LNB port on the decoder.

 

 

Octo LNB; 2 by 2x4 MS; 2 by ES 5-2; Dedicated PSU for LNB, ES's, MS's; HD PVR 4P x 2; Explora 1; DSD 660; FSM
New poster

HB between Explora 1 & 2

If I use a diplexer to run a UniCable from a 24-1z switch and a RF Out from a primary explora 1 and connect that single cable to a the UniCable port of a secondary explora 2 which is 30m away. Technically should that work allow the 2 exploras to communicate?