Explora 2A set as Primary should be connected to port A on the SLNB.
Explora 1 set as Secondary should be connected to port B on the SLNB, NOT one of the universal ports! You have to move the cable you used for the SD decoder from the universal port to Port B.
Then you need to set Explora 2A to use decoder 1 settings on the network settings.
Explora 1 set to use the decoder 2 settings.
Both the above settings are for the installation wizard.
Then you have to decide how you want to run the HB cable. You could leave it as it was connected to an RF port on both decoders.
All should now work after rebooting both decoders. I presume you have already got MC to sort out XV?
Octo LNB; 2 by 2x4 MS; 2 by ES 5-2; Dedicated PSU for LNB, ES's, MS's; HD PVR 4P x 2; Explora 1; DSD 660; FSM
I recently updated from explora 1 to explora 2. I have a smart lnb but can't seem to connect the explora 1 as a secondary decoder. All was set but i can't find the signal. I used an sd decoder as a secondary decoder. Now I can't figure this one out.
Solved! Go to Solution.