Welcome to Technical Info

cancel
Showing results for 
Search instead for 
Did you mean: 
Need help?

E143-4

3 REPLIES 3
Red Carpet

Re: E143-4

So that has fixed the issue?

If so then at least we know the following:

You are using either an SLNB or a SATCR LNB.

The HD PVR is set to default unicable UB and frequency settings.

The Primary decoder is set to non-default unicable settings.

 

Octo LNB; 2 by 2x4 MS; 2 by ES 5-2; Dedicated PSU for LNB, ES's, MS's; HD PVR 4P x 2; Explora 1; DSD 660; FSM
New poster

Re: E143-4

Thx - seems to have been factory reset affecting HD PVR. changed installation type to SATCR Univ.

Red Carpet

Re: E143-4

No need to post twice!  Stick to one post.

 

Check to see if the decoders received an update to new sw recently and report what the sw levels are on both.

What package?

What LNB is installed?

What are the network settings on both decoders?

The normal problem is the sw update resets the decoders to factory defaults which then leads to all sort of conflicts, which have to be corrected, but we can't advise as to what needs to be changed without knowing what your install looks like.

 

 

 

 

Octo LNB; 2 by 2x4 MS; 2 by ES 5-2; Dedicated PSU for LNB, ES's, MS's; HD PVR 4P x 2; Explora 1; DSD 660; FSM
New poster

E143-4

Decoder not receiving signal from primary decoder. nothing have changed in my setup. Explora primary and HD PVR secondary